Using The Pressure Washer - SNOWJOE SUNJOE SPX4600 Manual Del Operador

Fig. 10
High-pressure hose
m
WARNING!
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
11. Thread your garden hose (male end) into the garden hose
adapter (Fig. 11). The garden hose must have an
internal diameter of at least 13 mm (1/2 in.) and must be
reinforced. The water supply must be at least equal to the
washer delivery capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
Fig. 11
Water inlet
12. Attach garden hose to water supply (Fig. 12).
Fig. 12
Connect to water supply
Garden hose
m
WARNING!
m
WARNING!
system, the system shall be protected against backflow.
m
WARNING!
Water outlet
exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
Operation

Using the Pressure Washer

m
IMPORTANT!
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Position the washer as CLOSE as possible to the water
supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 13).
Fig. 13
Garden hose
3. Make sure the unit is switched off before plugging the unit
into the power outlet.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the rating plate.
If the power supply is correct, you may now plug the
pressure washer into the power outlet (Fig. 14).
9
Do not connect to potable water system.
If connection is made to a potable water
The intake water temperature must not
The washer must only be used with clean
This pressure washer is equipped with