Operation; Adjusting The Cutting Length; Switching The Device On And Off; Cleaning, Maintaining, Storing - Heiniger S tyle Mini (OT 11) Manual De Usario

Operation

Adjus ting the c utting length
W ithout c omb attac hment
Without comb attachment, the cutting length is 0.3 mm.
W ith c omb attac hment
The adjustable comb attachment [3] locks into the knife head [5] in 4 stages
from 3 to 6 mm.
Before cutting, check whether the desired cutting length has been set properly.
Use only original accessories.
S witc hing the devic e on and off
Actuate the on/off sliding switch [6].
S witc h pos ition
0
1
Devic e s tatus
The device is switched off.
The device is switched on.
C leaning, maintaining, s toring
C leaning the devic e
1. Using a damp cloth, wipe the device from time to time.
2. Then rub it dry.
C leaning the knife head
To avoid increased wear of the knife head and motor, the knife head must be
cleaned at regular intervals and oiled at appropriate locations.
In case of regular use, clean and oil the knife head thoroughly once daily:
1. Switch off the device.
2. Using the cleaning brush, remove hair carefully.
3. Detach the knife head [5] at regular intervals, to remove hair residue from
the insides of the device.
4. Press against the knife head from the top and detach it from the
device [A].
5. Use the cleaning brush [1] to remove hair between the inserts [B].
Operation
23