Nikken PiMag MICROJET Guia De Inicio Rapido página 3

a. Plastic end covers (to be discarded)
B. Plumbing tape
C. Rubber washers
D. MicroJet bracket mounting
E. Bracket mounting pipe stub
F. MicroJet flexible hose
g. hose hex nut
h. MicroJet hand unit (with filter cartridge inside)
I. hose round nut
J. Bracket hose retainer
Handheld model
1. Remove any showerhead that is already installed.
2. Take the MicroJet unit out of its packaging and remove
the three protective plastic covers (a) from both hose
connector nuts (g, I) and the end of the MicroJet hand
unit (h).
3. wrap plumbing tape (B) around the screw threads of
your shower plumbing pipe. Keep the tape surface flat
and wrap in a clockwise direction.
4. Make sure that the rubber washer (C) is in place inside
the connector in the top of the MicroJet bracket
mounting (D). attach this bracket to your plumbing
pipe.
5. wrap plumbing tape around the screw threads on
the pipe stub (E) on the side of the MicroJet bracket
mounting (D). Keep the tape surface flat and wrap in
a clockwise direction. Insert a rubber washer (C) in
the end of the MicroJet flexible hose (F) that has the
hexagonal (six-sided) nut (g). attach this end of the
flexible hose to the bracket pipe stub (E).
6. wrap plumbing tape to the connector on the bottom