DeLonghi AN Serie Manual Del Usuario página 10

Medium speed: reduces noise levels but still
maintains a good level of comfort;
Low speed: for silent operation.
PLEASE NOTE: To change the unit of measurement for the
displayed temperature, press the
for 3 seconds.
Setting the timer
The timer can be used to delay appliance start up or shut down.
This avoids wasting electricity by optimising operating periods.
How to programme delayed start up
• Plug the appliance into the mains socket. It will be in
STAND-BY.
• Press the timer button (D). The timer symbol (R) comes
on.
• Press the timer button (D). The timer light "H" flashes.
• Use the (F) or (C) buttons to set the number of hours
delay before the appliance comes on. They increase or
decrease the time in steps of an hour.
PLEASE NOTE: after setting, the operating mode and fan speed
can be modified.
To cancel the timer programme, press the timer button (D)
again. Pressing the ON/OFF button (A) cancels the timer
programme and the air conditioner comes on immediately in
the selected mode.
How to programme delay OFF
• Delay OFF can be programmed in any operating mode - air
conditioning/fan/dehumidifying.
• Press the timer button (D). The timer on symbol (R) comes
on.
°F
°F
°F
and buttons together
• Use the (F) or (C) buttons to set the number of hours
delay before the appliance goes off.
They increase or decrease the time in steps of an hour.
The appliance can be set to go off within the next 24 hours.
Five seconds after the timer has been set, the operating mode is
°F
displayed and the timer symbol remains on.
At the set time, the air conditioner goes off and remains in
stand-by.
To cancel the timer programme, press the timer button (D)
again. The timer symbol goes off.
PLEASE NOTE: after setting, the operating mode and fan speed
can be modified.
°F
OPERATING FROM THE REMOTE
CONTROL
Using the remote control
• Point the remote control at the receiver on the air
conditioner. The remote control must be no more than
16,4ft (5 meters) away from the appliance (without
obstacles between the remote control and the receiver).
• The remote control must be handled with extreme care.
Do not drop it or expose it to direct sunlight or sources of
heat.
PLEASE NOTE: The remote control can be safely stored in the
appropiate compartment (S) (see figure).
Description of the remote control
20) "ON/OFF" button
21) Temperature decrease/increase and
programme mode button
22) "MODE" button
23) "TIMER" button
24) °F/°C switching button
25) Fan speed button (MAX/MED/MIN)
9
MAX 16 ft
MAX 5 meters
°F