Settings; Spraying; Overheating Protection; Depressurising The Appliance - Parkside PAFS 550 A1 Traducción Del Manual De Instrucciones Original

Settings

♦ You can use the pressure regulator dial 3 to
switch the appliance on by setting a level greater
than 0 . The level you choose depends on the
spray material used . Determine the best setting
by carrying out a spray test .
♦ The function switch e has two settings:
–
1. PRIME (vertical position):
This setting allows you to pre-fill the system
with paint or to depressurise the appliance .
–
2. SPRAY (horizontal position):
You can use this setting to work with the
appliance .

Spraying

♦ Unlock the paint spray gun 7 by turning the
safety catch 6 so that its tip is facing down .
♦ To spray, press the trigger 9 and hold it down .
♦ To stop spraying, release the trigger 9 again .
WARNING!
► Always secure the paint spray gun 7 while
you are not actually spraying .
♦ Lock the paint spray gun 7 by turning the safety
catch 6 with the tip as far back and up as
possible .
PAFS 550 A1

Overheating protection

The appliance has an overheating protection .
It switches the appliance off if overheating is
imminent . If this happens, carry out the following
steps:
♦ Turn the pressure regulator dial 3 to position 0
(off) .
♦ Turn the function switch e to the vertical
position (PRIME) .
♦ Let the appliance cool down for at least
30 minutes and, if necessary, remove the cause
of the overheating . This could be, for example,
an item that is covering the ventilation slots or if
the appliance is too close to a wall .
♦ Put the appliance back into operation .

Depressurising the appliance

Always depressurise the appliance when you want
to take it out of operation . Depressurise the system
as follows:
♦ Turn the pressure regulator dial 3 to position 0
(off) .
♦ Turn the function switch e to the vertical posi-
tion (PRIME) .
♦ Unlock the paint spray gun 7 by turning the
safety catch 6 so that its tip is facing down .
♦ Release the pressure by pulling the trigger 9 .
Hold the paint spray gun 7 over an empty
container while doing so .
♦ Wait until all pressure and paint has been
dispelled from the system . To stop spraying,
release the trigger 9 again .
♦ Lock the paint spray gun 7 by turning the safety
catch 6 with the tip as far back and up as
possible .
GB │ MT │ 71 ■