Kobalt KAL124B-03 Manual Del Usuario página 9

OPERATING INSTRUCTIONS
5. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (G) with the hole on
the base of the area light.
b. Tighten the screw (H) securely with a Phillips
screwdriver (not included).
c. To remove the belt clip with bit holder, use a
Phillips screwdriver to loosen the screw holding
the belt clip to the area light.
6. USB port
When a battery pack is installed and the area light
is turned on, the USB port on the area light can
provide a 5 Volt DC, up to 2 Amp charging site for
your cell phone or other small USB device.
The area light and USB device should be placed
onto a flat surface during operation or can be hung
using the carry hook on the area light.
a. Attach a battery pack onto the area light.
b. Plug the USB cable (not provided) into the USB
port and the other end of the cable into your
device.
c. Press the ON/OFF switch to turn on the area
light and activate USB port.
d. The USB device will fully charge if there is sufficient charge in the battery pack.
e. When not using or after charging, remove the USB cable from the battery.
If the device draws more than the rated output of the port (Max. 2 A), the port will shut off to
protect the battery pack. To reactivate the USB, remove the device and press the ON/OFF
switch.
If the area light is turned off during USB charging, the USB port could provide additional 2
hours charging. Then it will automatically shut off.
NOTE:
• Charging time is dependent upon the device.
• The battery may warm with several continuous cycles, this is part of the normal operation,
always use the USB charging function in a well-ventilated area.
5
6
9
G
F
H