Looking After Your Product; Post Operation / Storage - NORSE PROFESSIONAL SK90 Manual De Operación

SK90

Looking After your Product

1. This pressure washer is not meant to pump hot water. Never connect to a hot water supply.
2. Never operate the unit for more than one minute without spraying water. This will cause a heat build-
up that can damage the pump.
3. Only use the nozzles supplied with the machine.
4. Never store the pressure washer outdoors or where it could freeze. The pump will be seriously
damaged. Any components with water left inside will also be damaged, e.g. the pressure gun.
5. Release the trigger when changing the spray pattern. Failure to do so could result in damage.
6. Do not operate the pressure washer with the inlet water screen removed. Be sure to keep the screen
clear of debris and sediment.
7. Make sure you clean the machine every three months and inspect the filter and the nozzle prior to
every use, ensuring there is no debris that may impair use.

Post Operation / Storage

• Do not store the pressure washer outdoors or in a location where it may freeze. Any water left in the
machine, gun or any other components will expand if allowed to freeze, causing damage.
• Always turn the motor off before turning the water supply off.
• Never disconnect the hose from machine while the system is pressurized. To de-pressurize, turn the
motor off, then turn the water supply off and squeeze gun trigger 2-3 times.
• Remove high pressure hose from the spray gun and the power washer.
• Remove extension lance and/or detergent bottle from the gun. Make sure to discard any remaining
detergent from the bottle. Flush the bottle and nozzle head with fresh water to prevent clogging.
• To release the high pressure hose from the unit, press the thumb tab down on the unit and the hose
will slide out from the connection.
• To release the high pressure hose from the spray gun, press the thumb tab on the underside of the
spray gun towards the trigger. The hose will slide out from the connections.
8
English
© NØRSE