Weelko MOVE Manual De Utilización página 12

Barcelona
Pol. Ind. La Valldan
Camí de Garreta 92
08600 Berga
Barcelona – Spain
T. +34 902 041 563
E.info@weelko.com
W. www.weelko.com
Instructions
11. In order to disinfect and protect the skin, clean and pat around
the whole face with a suitable astringent lotion and wait until it is
absorbed.
12. Apply toner on the skin, then press the ON/OFF switch so as to
start the operation.
13. Press the sonic wave switch to select the ultrasonic mode. The
pressing sequence is:
Continuous wave level 2  Level 3  Discontinuity wave level 1
 level 2  level 3  continuous wave level 1.
14. Press the ion switch to select microcurrent mode. The pressing
sequence is:
Clean+ level 2level3 Nutri- level1level 2level3EMS
level 1level2level 3Clean+ level1.
15. This equipment consists of 3 functions: 1. Cleansing, 2. Nutrition,
3. Wrinkle removing. Select the wave and the ion mode according
to your needs.
16. Place the shovel-type probe into contact with the skin to start
atomising the sebum of the pores. By slowly moving the probe
around the surface to be cleaned, you will start removing
blackhead, pimples and acne.
17. The function must be chosen according to the skin care products
used (cleansing remover gel or toner). The treatment should not
exceed the 10 minutes each time.
18. The probe and equipment must be kept cleaned and disinfected
with alcohol after using it.
19. Use continuous wave to clean the skin and remove dirt and the
discontinuity wave to perform massage or remove wrinkles.
20. The equipment will automatically get turned off after using it for
10 minutes.
21. Charge the equipment for one hour each time.
Technical specifications
INPUT: AC 100-240V 50/60Hz
OUTPUT: DC 5V 1A
POWER: 3W
12