Bose VIDEOWAVE Guia De Instalacion página 17

English Tab 2, 10
1. Press the power button ( ) on the control
console. The power light on the control
console indicates the startup status.
Power light
Status Meaning
Red Off
Blinking green Starting up
Steady green On and ready to use
Orange Off and charging iPod
Blinking yellow for 30 Unify™ system setup was started, but is
seconds after shutting incomplete
system down
Slow blinking red while Unify system setup is complete, but no
system is off sources are present
Red blinking off every 5 Remote control batteries are low
seconds
Tab 3, 11 Tab4, 12 Tab 6, 14 Tab 5, 13
Note: When the system starts up, you will hear a start-up
tone, and on the monitor screen you will see the Bose
logo with a progress bar under it.
2. Slide the battery compartment cover off the back
of the remote control.
3. Install the two AAA (IEC LR3) batteries (included),
matching the polarity markings (+ and –) to the
markings inside the battery compartment.
AAA (IEC LR3)
batteries (2)
4. Slide the battery cover back into place.
Tab 7, 15 Tab 8,16
I
NTERACTIVE SETUP
Battery compartment
cover
17