Shurhold PRO ROTARY POLISHER Manual De Instrucciones página 11

For best results, use Buff Magic, Buff Magic Pad, and our pad fluffing brush and follow
the steps below:
STEP 1
Choose the pad for the job. We recommend using Shurhold's Wool (medium cutting) or
Foam Buff Magic (light cutting) Pad. Be sure to start the job with a clean, dry pad.
STEP 2
Use a clean, small paint brush and apply a series of X's to a small 2 foot square area.
Do not apply the Buff Magic to the pad as this will cause premature overloading and
clumping of the pad.
STEP 3
Once the Buff Magic is on the surface, place the pad face directly on the surface of your
boat or vehicle and turn the machine on. Start at 600 RPM. Make sure you do not start the
machine until the pad is on the surface, as this will help to reduce slinging and mess of the
product.
STEP 4
As soon as the machine is on, use the following overlapping pattern. Do not apply a lot of
pressure, let the machine do the work for you.
STEP 5
You should slowly move through the overlapping
pattern a couple of times. If necessary, you can speed
up the tool to 1800–2500 RPM. Remember to turn the
tool off before removing it from the surface.
STEP 6
Use a microfiber towel to remove any excess
material. If the surface has the showroom shine you
are looking for, then you can move on to the next 2
foot square area. If not, you have a deeper level of
oxidation and you may have to repeat these steps a
couple more times.
www.shurhold.com
REMINDER:
Fluff the wool pad in between uses as this will help to keep
the pad from getting too matted down and stop working. Do
not use too much product, less is more. Never apply product
to the pad. Always work a small section at a time. Don't forget
once you are done with the steps above, you will want to
put a protective coating on the surface to prevent premature
oxidation in the future.
BEGIN HERE
11