Manual Mig/Mag Welding; Synergic Mig/Mag Welding; Pulsed Synergic Mig/Mag Welding; Double Pulsed Synergic Mig/Mag Welding - Weco Digimanager 501W Manual De Instrucciones

Digimanager
8

MANUAL MIG/MAG WELDING

In this welding mode the following parameters can be adjusted:
S1 Press and release the button to select the parameter to be edited.
S3 / S4 Use these buttons to change the parameter value.
9

SYNERGIC MIG/MAG WELDING

10

PULSED SYNERGIC MIG/MAG WELDING

11

DOUBLE PULSED SYNERGIC MIG/MAG WELDING

In this welding mode the following parameters can be adjusted:
S1 Press and release the button to select the parameter to be edited.
S3 / S4 Use these buttons to change the parameter value.
12

LOADING A USER JOB

Press the key S1 until the acronym -J- appears.
After releasing the key the number of the first loadable JOB will be displayed.
Select the JOB to be loaded by pressing the keys S3/S4.
Confirm it by holding down the key S1 for more than 3 seconds; after releasing the key the wording "Jxx"will be displayed, xx= number of JOB
loaded.
Press the key S1 to scroll through the parameters and view them on the display. The value is displayed for 3 seconds.
Whist the parameter is being displayed, its value can be changed by pressing the keys S3/S4.
When a parameter is changed the JOB is quit.
ACRONYM
-M-
-U-
-J-
ACRONYM
-M-
-A-
-t-
-C-
-J-
PARAMETER
Wire feed rate
Volts
JOB to be loaded
This item only appears when there are saved JOBs.
PARAMETER
Wire feed rate
Amperes
Welding thickness
Arc correction
JOB to be loaded
This item only appears when there are saved JOBs.
Cod.006.0001.1292
21/04/2021 v1.4
ENGLISH
7/22