Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROLLER
Replacement of Batteries
Remove the battery cover plate from the rear of the remote controller,
by sliding it in the direction of the arrow.
Install the batteries according the direction (+ and -) shown on the
Remote Controller.
Reinstall the battery cover by sliding it into place.
Use 2 LRO 3 AAA (1.5V) batteries. Do not use rechargeable
batteries. Replace the old batteries with new ones of the same
type when the display is no longer legible.
Do not dispose batteries as unsorted municipal waste. Collection
of such waste separately for special treatment is necessary. Refer
to picture 1:
i. When you open the battery cover, you can see a DIP switch on
the cover back.l
DIP switch on position Function
C
F
Cool
Heat
ii. NOTE: After adjusting the function, you need to take
out the batteries and repeat the procedure described above.
Refer to picture 2:
When you insert the batteries for the first time in the remote
controller or if you change them, you need to program the remote
controller of only cooling or cooling and heating.
When you insert the batteries, the symbols
(
) start fashing. If you push whatever button when
HEAT
the symbol
(
COOL
adjusted in only cooling mode . If you push whatever button when
the symbol
(
HEAT
adjusted in Cooling and heating mode.
NOTE: If you adjust the remote controller in cooling mode,
it will not be possible to activate the heating function in units with
heating pump, you will need to take out the batteries and repeat the
procedure described above.
1. Direct the remote controller toward the air conditioner.
2. Check that there are no objects between the remote controller
and the Signal receptor in the indoor unit.
3. Never leave the remote controller exposed to the rays of the sun.
4. Keep the remote controller at a distance of at least 1m from the
television or other electrical appliances.
Recommendations for locating and using the remote controller holder (if present).
The remote controller can be kept in a wall-mounted holder.
Remote controller holder
The remote controller is adjusted in degree celsius
The remote controller is adjusted in degree fahrenheit.
The remote controller is adjusted in only cooling mode
The remote controller is adjusted in cooling and heating mode
) is displayed, the remote controller is
) is displayed , the remote controller is
FEEL
COOL
DRY
FAN
HEAT
COOL
(
) and
10
FAN
FEEL
SPEED
COOL
AIR
DRY
SWING
FAN
HEAT
HEALTHY
HEALTHY
TIMER
Signal
receptor
FAN
SPEED
AIR
SWING
TIMER
Publicidad
