Registering The Camera; Using The App; Confirming The Registration Area - Panasonic KX-HNC600 Guia De Instalacion

Setup

Registering the camera

This procedure is not required for devices
that were included as part of a bundle.
Before you can use the camera, it must be
registered to the hub.
If the camera is not registered to a hub, the
camera's LED indicator blinks in amber.
You can register each device by using the
registration buttons or the [Home Network]
app.
Note:
R Before registering the camera, make sure
the AC adaptors of the hub and camera are
connected and each device is powered.
Using registration buttons
1
Hub:
Press and hold M
LED indicator blinks in green.
2
Camera:
Using an object with a thin tip, press and
hold M N until the LED indicator blinks
in green (page 15).
R When registration is complete, the hub
sounds one long beep.
Note:
R To cancel the registration, press the
registration button on the hub and on the
camera.
R If registration fails, the hub sounds several
short beeps.
For assistance, please visit www.panasonic.com/support
16

Using the app

When you register the camera by using the
[Home Network] app, you can assign a name
to your devices and group them by location.
For more information, refer to the User's
Guide (page 26).
Confirming the registration
area
Before deciding where to install the camera,
carefully read the chapter "Installation
Location", beginning on page 8, to confirm the
installation location and direction.
CAMERAN until the