Frigidaire FRSS2323AS Uso Y Cuidado página 17

In-Door Control Display Mode Views
Your display is equipped with a sleep and inactive mode to prevent accidental changes
to the unit settings during opening and closing of the doors. When both doors are
closed, the display will be in sleep mode. When either door is first opened, the display
will be in inactive mode where all the current settings are visible but dimmed.
Pressing any button on the display will activate the display and a tone will be played.
All settings will then be fully lit. Touch the display again to change any setting.
If there is no button pressed for 10 seconds while any door is open, the display will
default back to inactive mode.
Temperature
Adjust the temperature gradually: adjust in small increments, allow-
Adjustment
ing the temperature to stabilize.
•
•
Adjusting the refrigerator control will change temperature in both
compartments. The freezer control can be left at the factory preset
(*Recommended) or adjusted as desired.
To maintain temperatures, a fan circulates air in the refrigerator and
freezer compartments. For good circulation, do not block cold air
vents with food items.
Air Filter The display shows the current status of the air filter (Good, Order, or
Status* Replace). To reset the filter status to Good, press and hold Air Filter
for 3 seconds.
Water Filter
The displays shows the current status of the water filter (Good,
Status Order, or Replace). To reset the filter status to Good, press and hold
Water Filter for 3 seconds.
CONTROLS AND SETTINGS
For colder temperatures, press the Temp button to change the
temperature setting toward Coldest.
For warmer temperatures, press the Temp button to change the
temperature setting toward Cold.
*Only on some models
17