Assembly - GreenWorks HTA22 Manual Del Operador

WARNING:
DO NOT USE an extension boom with this
product. It is not designed to be used with an extension
and using one may cause serious injury.
INSTALLING AND REMOVING THE ATTACHMENT
The coupler enables the use of various optional attachments.
WARNING:
Before using any attachment, read and
understand the manual that came with the attachment.
Follow all safety information contained within.
WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before removing or
installing an attachment.
Installing the Attachment
1. Remove the protective cap from the attachment. If present,
remove the gray spacer from the coupler.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise to loosen the coupler (Fig. 1).
4. Push the attachment straight into the coupler (Fig. 2) until the
release button snaps firmly into the 90º hole (Fig. 3).
5. Turn the knob clockwise to tighten the coupler (Fig. 1).
WARNING:
Before operating the unit, make sure the
release button is fully snapped into the 90º hole and the
knob is securely tightened. Using the wrong hole could
lead to personal injury or damage to the unit.
Removing the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen the coupler (Fig. 1).
3. Press and hold the release button (Fig. 3).
4. Pull the attachment straight out of the coupler (Fig. 2).

ASSEMBLY

Tighten
Release Button
8
Loosen
Fig. 1
Coupler Attachment
Fig. 2
Fig. 3
Knob
90˚ Hole