General Specifications - Yamaha RY16-ML-SILK Manual De Instrucciones

Analog Input Characteristics
Input
Gain
Terminals
+66dB
CH 1 – 16
-6dB
*1 In these specifications, when dBu represents specific voltage values, 0dBu is referenced to 0.775 Vrms.
*2 1=GND, 2=HOT, 3=COLD
*3 CH1 – 16 AD converters are 24 bit linear.
*4 +48V DC (phantom power) is individually supplied to CH1 – 16 XLR connectors via each individual software controlled switch.
Dimensions (W x H x D) and Net Weight:
Included Accessories:
RY16-DA

General Specifications

Measured with an RPio622
Frequency Response
Fs=44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz @ 20 Hz – 20 kHz, reference to the nominal output level (-20dBFS) @ 1 kHz
Input Output
DIGITAL IN CH1 – 16
Total Harmonic Distortion
Fs=44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Input Output
DIGITAL IN CH1 – 16
Total Harmonic Distortion is measured with an 18dB/octave filter @ 80 kHz.
Hum & Noise
Fs=44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Input Output
DIGITAL IN CH1 – 16
Hum & Noise is measured with an IHF-A filter.
Dynamic Range
Fs=44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Input Output
DIGITAL IN CH1 – 16
Dynamic range is measured with an IHF-A filter.
Actual Load For Use with
Impedance Nominal
50 – 600 Ω Mics &
10 kΩ
600 Ω Lines
405 mm x 42 mm x 258 mm, 1.6 kg
Owner's Manual
RL
600 Ω
RL
Full scale output @ 1 kHz
600 Ω
+4dBu output @ 20 Hz – 20 kHz
RL
600 Ω Digital data: OFF
RL
600 Ω
Input Level
Nominal
(-20dBFS)
-62dBu (616 uV) -42dBu (6.16 mV)
+10dBu (2.45 V)
Conditions
–
Conditions
Conditions
Conditions
–
Connector
Max
(0dBFS)
XLR-3-31
type
+30dBu (24.5 V)
Min. Typ
-0.8 –
Min. Typ
– –
– –
Min. Typ
– -92
Min. Typ
– 116
Balanced /
Unbalanced
Balanced
*2
Max. Units
0.5 dB
Max. Units
0.006 %
0.02 %
Max. Units
– dBu
Max. Units
– dB