Waterco LACRONITE ECO-V Serie Instruction página 3

Adjusting Low (ECO), MED and HIGH Speed Settings
1. While the Lacronite ECO-V is operating press and hold the required speed setting button
for 3 seconds or until the indicator light is flashing. This will allow the factory setting to be
adjusted either down or up in RPM's.
2. To decrease the speed of a factory speed setting select and
press the speed button, the indicator light will begin to flash.
Press the ECO with down arrow button, to decrease the RPM
by 25 RPM each time you press the button, until you reach the
desired operating RPM.
Note: The minimum operating RPM limit is 1000 RPM.
3. To increase the speed of a factory speed setting select and press the speed
button , this will then have the flashing indicator light. Press the HIGH with up
arrow button as this will increase the RPM by 25 RPM each time you press
until you reach the desired operating RPM.
Note: The maximum operating RPM limit is 25 RPM less than the next factory
speed setting.
Example: Low (ECO 1900 RPM) upper RPM limit is 2375 RPM, 25 RPM below
MED factory setting of 2400 RPM.
4. To save this variable speed adjustment hold MED/OK button for 5 seconds to
return to normal operating mode.
Please ensure that the correct pump speed is selected in accordance to the pool
equipment and adequately meets the pool's requirements.
Benefits of Slow Flow
Lowering a pumps flow rate not only significantly decreases the pump's energy requirements,
but also reduces water flow resistance in your pool equipment and plumbing. Even though you
may need to operate the Lacronite ECO-V longer, it is far more efficient pumping low water flow
compared to high water flow.
A slow flow rate also has the added benefit of improving your pool's filtration efficiency,
enhancing the clarity of your swimming pool water. Plus your automatic chemical dosers and
salt chlorinators are also more effective when the pool water is circulated longer.
Ultra Quiet
Lacronite ECO-V operates most economically and with the lowest noise level at its low speed
setting. Its low speed setting significantly reduces the pump's vibration, motor noise and water
turbulence to an ultra low 64.3 decibels (dBA).
Off-Peak Operation
Its low noise levels enable it to be operated at times that are not allowable for conventional pool
pumps. A Lacronite ECO-V allows you to take advantage of off-peak electrical tariff periods,
without upsetting your neighbours.
Lacronite ECO-V Multi Speed Pump I pg 02