Contents Of Carton; Tools Required For Assembly; Grounding Instructions - Speedaire Site Boss Manual De Instrucciones De Operación Y Lista De Partes

Speedaire Operating Instructions and Parts Manual
Model 1WC94
Assembly

CONTENTS OF CARTON

1 - Air Compressor
2 -Wheels
2 - 3/8-16 Shoulder Bolts
2 -3/8-16 Hex Nuts
2 -Rubber Bumpers
2 -Screws
1 -Quick Connect Plug
1 -Quick Connect Body
1 -Brass Connector
TOOLS REQUIRED FOR
ASSEMBLY
1 - 9/16" socket or open end
wrench
1 - 3/8" socket or open end
wrench
1 - 1/4" socket or open end
wrench
The wheels
and handle do not provide
adequate clearance, stabil-
ity or support for pulling
the unit up and down
stairs or steps. The unit
must be lifted, or pushed
up a ramp.
It may be nec-
essary to brace or support
one end of the outfit
when attaching the
wheels and the rubber
feet, because the air com-
pressor will have a ten-
dency to tip.
1. Place shoulder bolt (C)
through wheel (B) and po-
sition it into the hole of
the mounting bracket
(protruding hub to the
inside). Thread nut (A)
onto shoulder bolt and
tighten firmly with a 9/16"
wrench. Repeat to install
second wheel.
A
B
D
E
2. Attach the rubber feet
(D) to the bottom of the
front bracket using the
screws (E) provided.
3. Rotate handle into oper-
ating position as shown
in Figure. NOTE: Handles
will lock into place.
Installation
LOCATION OF THE AIR
COMPRESSOR
Locate the air compressor in a
clean, dry, and well-ventilat-
ed area. The air filter must be
kept clear of obstructions
which could reduce air flow
9
to the air compressor. The
air compressor should be
located at least 12" away
from the wall or other
obstructions that will inter-
fere with the flow of air. The
air compressor head and
shroud are designed to allow
for proper cooling. If humidi-
ty is high, an air filter can be
installed on the air outlet
adapter to remove excessive
moisture. Follow the instruc-
tions packaged with the air
filter for proper installation.
GROUNDING
C
INSTRUCTIONS
ELECTRICAL SHOCK. In
the event of a short cir-
cuit, grounding reduces
the risk of shock by pro-
viding an escape wire for
the electric current. This
air compressor must be
properly grounded.
The portable air compressor
is equipped with a cord hav-
ing a grounding wire with
an appropriate grounding
plug (see following illustra-
tions). The plug must be
used with an outlet that has
been installed and grounded
in accordance with all local
codes and ordinances.
1. The cord set and plug
with this unit contains a
grounding pin. This plug
MUST be used with a
grounded outlet.
E
N
G
L
I
S
H
RISK OF