Detergent Application; Maintenance And Cleaning; Surface Preparation - Casals JHB70 Manual Del Usuario

JHP18
- Open the soap bottle and fill it with an ade-
quate cleaning product, suitable for this kind of
products. Secondly, turn the pressure rib to the
right to lower the pressure on the spray nozzle
so it can take the detergent and use it to clean
(Fig. 7).
- To remove the appliance from taking detergent,
turn the pressure ring to gain pressure and stop it.
ANGLE TO THE CLEANING SURFACE
- For your knowing, maximum impact of water
to the surface you want to clean is when you
point perpendicularly the surface. However, this
high impact may cause the dust particles to get
imbed in the surface, difficulting the cleaning
operation you want to do.
- The optimum angle for spraying water against a
cleaning surface is 45 degrees.
- Distance from cleaning surface
- The optimum cleaning distance is 50 cm away
from the surface. However, if the dirt is not
removed with this distance, you can get closer,
so the impact force will increase.
- WARNING: if the surface is not strong enough it
could give in, so it could get rumpled.
HOW TO AVOID DAMAGING SURFACE
- By controlling the parameters explained before,
you can adjust the hitting force of the water
stream, so then you can regulate. The best way
is to start with a complet 60º of the nozzle, at
45º and 50 cm away. Then you can start modi-
fying these parameters.
OPERATION
- Mount the appliance acoording to the mounting
the appliance section on this manual.
- Prepare the appliance to the suitable use you
need to do.

SURFACE PREPARATION

- Before starting, make sure the cleaning surface
is prepared to be cleaned. Also prepare the
environment. If there are plants or trees, be
assured to cover them with drop clothes. This
will ensure that your plants are not sprayed with
detergent.
INITIAL HIGH-PRESSURE RINSE
- Adjust the spry nozzle to a wide fan position so
you won't apply too much concentrated spray to
the surface and avoid to damage the surface.

DETERGENT APPLICATION

- WARNING: Always use the appropriate
instructions or model purchased. See them in
detergent applications section.
- WARNING: Follow the detergent manufacturer's
label instructions in order to mix the correct pro-
portions between water and dtetergnt (normally
around 5% detergent per 95% water).
FINAL RINSE
- Once you finished applying detergent, change
the detergent applicator (depending on model)
or raise the pressure on the spray nozzle,
and use water to wash up and remove all the
detergent.
AFTER-USE
- Turn the appliance off and disconnect I from the
mains and the water supply.
- Trigger the gun to depressurize the system so
no damage can occure while dismounting the
appliance.
- CAUTION: Never turn the water supply off
without turning off the appliance. Serious dama-
ge can be caused to the pump and/or motor.
- WARNING: Despressurize the system every
time before dismounting the appliance.
- After each use, wipe all surfaces with a clean,
dry cloth.

MAINTENANCE AND CLEANING

- Clean and wipe the exterior of the appliance
and all accessories removing all remaining
water with a drop cloth.
- Regularly check for obvious defects suhch as
loose fixings and worn or damaged compo-
nents.
- Empty the detergent tank and clean it with
current water, so all the remaining detergent is
wiped out.
STORAGE
- Do not store pressure washers outdoors.
- Do not store pressure washers where it may
freeze.