Publicidad
Idiomas disponibles
Idiomas disponibles
8. Tighten the three hex flange head bolts (with
the socket wrench provided) and hand rotate
the drum to check clearances between the
blade ends and the tool body.
9. Check the three hex flange head bolts for
final tightness.
0. Repeat procedures - 9 for other blade.
For the correct planer blade setting
Your planing surface will end up rough and
uneven, unless the blade is set properly and
securely. The blade must be mounted so that
the cutting edge is absolutely level, that is,
parallel to the surface of the rear base.
Below are some examples of proper and
improper settings.
(A) Front base (Movable shoe)
(B) Rear base (Stationary shoe)
Correct setting
Although this side view cannot show it, the
edges of the blades run perfectly parallel to the
rear base surface.
Nicks in surface
Cause: One or both blades fails to have edge
parallel to rear base line.
Gouging at start
Cause: One or both blade edges fails to
protrude enough in relation to rear base line.
Gouging at end
Cause: One or both blade edges protrudes too
far in relation to rear base line.
OPERATION
Planing operation
. End
. Start
First, rest the tool front base flat upon the
6
Publicidad
