Descargar Imprimir esta página

ASROCK Z68 Extreme7 Gen3 Manual Del Usuario página 35

Publicidad

2.8 ASRock Smart Remote Installation Guide
ASRock Smart Remote is only used for ASRock motherboard with CIR header.
Please refer to below procedures for the quick installation and usage of ASRock
Smart Remote.
Step1.
Find the CIR header located next
to the USB 2.0 header on ASRock
motherboard.
Step2.
Connect the front USB cable to the
USB 2.0 header (as below, pin 1-5)
and the CIR header. Please make
sure the wire assignments and the
pin assignments are matched
correctly.
Step3.
Install
Multi-Angle CIR Receiver
the front USB port. If
CIR Receiver
cannot successfully
receive the infrared signals from
MCE Remote Controller, please try
to install it to the other front USB
port.
1.
Only one of the front USB port can support CIR function. When
the CIR function is enabled, the other port will remain USB
function.
2.
Multi-Angle CIR Receiver
not use the rear USB bracket to connect it on the rear panel.
Multi-Angle CIR Receiver
signals (top, down and front), which is compatible with most of
the chassis on the market.
3.
The Multi-Angle CIR Receiver
function. Please install it before you boot the
* ASRock Smart Remote is only supported by some of ASRock motherboards. Please refer to
ASRock website for the motherboard support list: http://www.asrock.com
ASRock Z68 Extreme7 Gen3 Motherboard
USB_PWR
P-
P+
GND
1
2
3
GND
IRTX
IRRX
ATX+5VSB
to
Multi-Angle
3 CIR sensors in different angles
is used for front USB only. Please do
can receive the multi-direction infrared
does not support Hot-Plug
USB 2.0 header (9-pin, black)
CIR header (4-pin, gray)
DUMMY
4
5
system.
35

Publicidad

loading