Handle Assembly - Kenmore 721.33189 Manual Del Propietário

Before assembling your vacuum, check the
PACKING LIST on the cover of the separate
Parts List. Use this list to verify that you have
received all the components of your new
Kenmore vacuum.
WARNING
Electric Shock Hazard
Do not plug into the electricalsupply until
the assembly is complete.
Failure to do so could result in electric
shock or injury.
HANDLE ASSEMBLY
Remove the screw located just below the top
edge of the back of the vacuum.
Position the handle as shown below and slide
the handle into the opening at the top of the
vacuum.
Insert the screw so it passes through the
handle into the vacuum.
H.
Handle
/11_/_ "_ "'_. Screw
I ! , ,ll l/ Irl. _.._J'_Hole
Tighten the screw securely with a screwdriver.
It may be necessary to adjust the handle
slightly.
CAUTION
Do not overtighten.
Overtightening could strip the screw holes.
Do not operate the cleaner without the
screw in place.
-5-