Pet Fountain Disassembly & Cleaning - Drinkwell DOGC-AU-17 Manual De Funcionamiento

9. Check the Reservoir Cap to make sure the black O-ring is in place, then screw the
Reservoir Cap onto the Reservoir.
10. Hold the Reservoir over the Reservoir base of the Pet Fountain. Quickly turn the
Reservoir upside down and place the spout of the Reservoir Cap into the Reservoir
base (Fig. 3).
1 1. Set your desired flow rate with the Flow Control Knob, which is next to the ramp
inside the Bowl. When the Flow Control Knob is in the 10 o'clock position, flow is
at its lowest. When the Flow Control Knob is in the 2 o'clock position, flow is at its
highest (Fig. 4).
12. Add water to the Bowl as needed. Do not let the water level fall below the Flow
Control Knob or you may risk Pump failure. Replacement pumps are sold seperately
by contacting Customer Care Centre. Visit www.petsafe.net for a telephone listing of
the Customer Care Centre near you.
Pet Fountain Disassembly & Cleaning
Important: Pet Fountain must be cleaned to continue working normally.
CHARCOAL FILTER: The Charcoal Filter should be changed every two to four weeks.
1. Replace the Charcoal Filter more frequently when using the Pet Fountain for multiple
pets or pets that produce a lot of saliva.
2. The Charcoal Filter is an added feature of the Pet Fountain. The use of a filter is
not required for normal operation, but using a filter will keep the Pet Fountain
water cleaner.
3. The Charcoal Filter may be rinsed out when the Pet Fountain is cleaned.
• Do not wash with soapy water, as you will not be able to remove the
soap residue. Only rinse the filters with water.
• Use only PetSafe
unauthorised filters are used it may void the warranty.
8
Fig. 3
Fig. 4
brand authorised replacement filters. If
®
www.petsafe.net
Flow Control Knob