Publicidad
Idiomas disponibles
Idiomas disponibles
Accessory: telephone
cable.
Accessory:
doorbell cable.
Congratulations on purchasing your
combi I RF. We hope it will give you
many years of reassuring operation.
Please read through these operating
instructions carefully. They tell you
how to set up the system correctly
and explain all the system's features
to you.
Standard components
Please check if all following compo-
nents are included:
- lisa combi I RF
- 1 x Telephone cable, 6 m
- 2 x Doorbell cable, 1 m
- 9 V block battery
- Operating Instructions
- Warranty card
If any parts are missing please imme-
diately contact your dealer or the
manufacturer directly.
Operating principle
A signalling system consists of at
least one transmitter and one recei-
ver. The combi I RF picks up the rin-
ging signals from telephone and
doorbell through an electrical conne-
ction. It converts these signals into
radio pulses (868.35 MHz) and trans-
mits them to the receiver without the
need for wires.
Special features
When a signal is detected, it is trans-
mitted for a total of 22 seconds. This
increases both the reliability and the
range of the system.
Setting up the system –
1. Inserting the battery
There is a battery compartment on
the back of the direct-connection
radio tdoorbell transmitter. Open it by
sliding the cover of the battery com-
partment to the right of the transmit-
ter using your thumb. Plug the termi-
nals of a 9 V battery into the connec-
tion adapter. Insert the battery into
the compartment and fit the cover
back into place.
It is possible that the transmit signal
may be triggered once when you
connect the battery.
English 11
Publicidad
