Publicidad
PRECAUCIÓN: La palanca de levantamiento
está accionada por resorte. Sosténgala firmemente
apretada, bájela lentamente y engánchela en la
posición más baja. La palanca de levantamiento se
encuentra en el lado izquierdo de la defensa.
Palanca De
Levantamiento
2. ARME LA RUEDA CALIBRADORA DELAN-
TERA (W) EN LA PARTE DELANTERA DE
LA CORTADORA DE CÉSPED
W
H
X
Y
Z
H. Escuadra De La Cortadora De Césped
Delantera
W. Rueda Calibradora Delantera
X. Perno Con Resalto
Y. Arandela De 1-1/4
Z. Tuerca De Seguridad De 3/8-16
K
C
I
C
A. Brazos De Suspensión Lateral De La
Cortadora De Césped
B. Resorte De Retención
C. Eslabones De Levantamiento Traseros
D. Escuadra Trasera Derecha De La Cortadora
De Césped
E. Conjunto De Eslabones De Levantamiento
Delanteros
F. Escuadra De Suspensión Delantera
H. Escuadra De La Cortadora De Césped
Delantera
3. GIRE EL VOLANTE HACIA LA IZQUIERDA
Y UBIQUE LA CORTADORA DE CÉSPED
EN SU LUGAR
•
Gire el volante completamente hacia la
izquierda y ubique la cortadora de césped
en el lado derecho del tractor con el blindaje
deflector (Q) a la derecha.
Parte Delantera
Motor
Transeje
02965
Parte Trasera
Q. Blindaje Deflector
4. DESLICE LA CORTADORA DE CÉSPED
DEBAJO DEL TRACTOR
•
Lleve la correa hacia adelante y verifique que
su trayectoria sea correcta en todos los surcos
de la polea de la cortadora de césped.
NOTA: Asegúrese de que los brazos de
suspensión lateral de la cortadora de césped (A)
estén orientados hacia adelante antes de deslizar
la cortadora de césped debajo del tractor.
•
Deslice la cortadora de césped debajo del
tractor hasta que se encuentre centrada
debajo del tractor.
F
M
B
L
A
E
S
D
I. Escuadra Trasera Izquierda De La
Cortadora De Césped
K. Varilla Tensora De La Correa
L. Escuadra De Bloqueo
M. Polea Del Embrague Del Motor
Q. Blindaje Deflector
S. Barra Antibalanceo
W. Rueda CalIbradora Delantera
44
TO CHECK BRAKE
If tractor requires more than five (5) feet to
stop at highest speed in high est gear on a
level, dry concrete or paved surface, then
brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or
paved surface, depress brake pedal all
Q
the way down and engage parking brake.
2. Disengage transmission by placing
freewheel control in "transmission dis-
engaged" position. Pull freewheel control
out and into the slot and release so it is
held in the disengaged position.
The rear wheels must lock and skid when
you try to manually push the tractor forward.
If the rear wheels rotate, then the brake
needs to be serviced. Contact a Sears or
other qualified service center.
FRONT WHEEL TOE-IN/CAM BER
Your new tractor front wheel toe-in and cam-
ber is set at the factory and is normal. The
front wheel toe-in and camber are not adjust-
able. If damage has occurred to affect the
factory set front wheel toe-in or camber, con-
tact a Sears or other qualified service center.
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key - Do not lose).
3. Repair tire and reassemble.
NOTE: On rear wheels only: align grooves in
rear wheel hub and axle. Insert square key.
4. Replace washers and snap retaining ring
securely in axle groove.
5. Replace axle cover.
W
NOTE: To seal tire punctures and pre vent
flat tires due to slow leaks, purchase and
use tire sealant from Sears. Tire sealant also
pre vents tire dry rot and corrosion.
Washers
H
Retaining
Ring
Q
Axle Cover
TO START ENGINE WITH A WEAK BAT-
TERY
WARNING: Lead-acid batteries gen er-
ate ex plo sive gases. Keep sparks, flame
and smoking ma te ri als away from bat ter ies.
Always wear eye pro tec tion when around
batteries.
If your battery is too weak to start the engine, it
should be recharged. (See "BATTERY" in the
MAINTENANCE section of this man u al).
If "jumper ca bles" are used for emer gen cy
starting, follow this pro ce dure:
IMPORTANT: Your tractor is equipped with
a 12 volt system. The other vehicle must also
be a 12 volt system. Do not use your tractor
battery to start other vehicles.
TO ATTACH JUMPER CABLES
1. Connect one end of the RED cable to the
POSITIVE (+) terminal of each battery(A-
B), taking care not to short against tractor
chassis.
2. Connect one end of the BLACK ca ble
to the NEGA TIVE (-) terminal (C) of fully
charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground, away
from fuel tank and bat tery.
T O R E M O V E C A B L E S , R E V E R S E
ORDER
1. BLACK cable first from chassis and then
from the fully charged battery.
2. RED cable last from both batteries.
Weak or Dead
Battery
Square Key (Rear
Wheel Only)
29
Fully Charged
Battery
Publicidad
