AEG X89491BH1 Manual De Uso página 6

6 www.aeg.com
4. MAINTENANCE
ATTENTION! Before performing any
maintenance operation, isolate the
hood from the electrical supply by
switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
The cooker hood should be cleaned
regularly (at least with the same frequency
with which you carry out maintenance of the
fat filters) internally and externally. Clean
using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
Warning! Failure to carry out the basic
cleaning recommendations of the
cooker hood and replacement of the
filters may cause fire risks. Therefore,
we recommend observing these
instructions.
The manufacturer declines all responsibility
for any damage to the motor or any
fire damage linked to inappropriate
maintenance or failure to observe the above
safety recommendations.
4.1 Grease filter - The grease filter must
be cleaned once a month using non
aggressive detergents, either by hand or
in the dishwasher, which must be set to a
low temperature and a short cycle. When
washed in a dishwasher, the grease filter
may discolour slightly, but this does not
affect its filtering capacity.
4.2 Charcoal filter - The saturation of the
charcoal filter occurs after more or less
prolonged use, depending on the type of
cooking and the regularity of cleaning of the
grease filter.
In any case it is necessary to replace the
cartridge at least every four mounths.
The charcoal filter may NOT be washed or
regenerated.
5. CONTROLS
Warning!When using or handling the
hood, do not leave hands within the
range of action of the suction panel
(pull-out drawer).
1 2
1 - Delays hood switching off timing the
speed set for some minutes.
By such function, when the timing is
elapsed, the hood switches off.
The timing is divided as follows:
• suction speed (power) 1: 20 minutes
• suction speed (power) 2: 15 minutes
• suction speed (power) 3: 10 minutes
• suction speed (power) 4: 5 minutes
N.B.: when the Timer is activated at
suction speed 4 (power), the hood
could switch to speed 3 before going
off, since speed 4 already has a preset
timing when the speed is reduced.
When keys 2 and
hood leaves the timed function and
the suction speed (power) increases
or decreases according to the key
pressed. During the timing phase the
LED related to the corresponding
speed flashes.
3 4 5
3 are pressed, the