Troubleshooting - auna Oldschool Manual De Instrucciones

EN
46

TROUBLESHOOTING

Symptom Possible Cause
The unit is disconnected from
The unit does not
the AC outlet.
respond (no
power)
The AC outlet has not power
Unit is ON but Volume set too low.
there is
low or no volume
Unit not in Radio mode.
AM/FM no sound
Unit is not linked with your
BT enabled device.
BT No Sound Unit placement out of range.
Your BT enabled device
volume set too low.
Station not tuned properly.
Noise or sound
FM: telescopic antenna is not
distorted
fully extended.
on FM broadcast.
AM: Internal antenna is not
positioned correctly.
Unit not in USB function
mode.
USB player will
not play
Can't read USB data.
Unit not in CD function
mode.
CD player will
CD is installed incorrectly.
not play.
CD player will
not play. If the CD is self-compiled, the
media used may not be
compatible with the player
Solution
Reconnect to the AC outlet.
Try the unit on another outlet
Slowly rotate the MASTER
VOLUME knob to increase the
volume level.
Slide FUNCTION switch to
select RADIO.
Go through "BT
Operations"process to link
the speakers.
Relocate the unit within BT
operating range (30 feet).
Increase Volume level of your
BT enabled device.
Fine tune the FM broadcast
station.
Fully extend the FM
telescopic antenna.
Reposition the unit until the
best reception is obtained.
Slide FUNCTION switch to
CD/USB and long press the
CD/USB/PAIR/  button
until USB indicator is flashing
USB flash drive fault, change
another good one.
Slide FUNCTION switch to
select CD.
Insert CD with label side
outward.
Use better quality blank
media and retest.