Assembly Instruction - Genesis GWL13130T Manual Del Operario

KNOWING YOUR WORK LIGHT
3
4
2
5
6
7
8

ASSEMBLY INSTRUCTION

SETTING UP THE TRIPOD
1.
Loosen the tripod locking knob (F).
2.
Push down the leg connector (A) until the legs (B) are fully
extended and firmly tighten the locking knob (F).
3.
Adjust the height of the tripod by loosening the twist collars (C1
& C2) and raising the center poles (D1 & D2) of the tripod. Firmly
tighten the twist collars when the tripod reaches the desired
height.
ATTACHING THE CARRYING HANDLE TO THE
STAND (FIG 2)
1.
Place the carrying handle (1) vertically on the stand (7).
2.
Use two hex screws (15) to secure the carrying handle on the
stand as shown in FIG 2.
ATTACHING THE WORK LIGHT HEADS TO THE
STAND (FIG 2, 3)
1.
Place the stand (7) on a flat surface.
2.
Use the locking knobs (8), to secure both work light heads on
the sides of the stand as shown in FIG 2.
3.
Use a screw (12) to attach the power cable connector (13) to the
carrying handle as shown in FIG 3.
1
2
5
6
9
10
11
1.
Carrying Handle
2.
Work Light Heads
3.
Lenses
4.
LEDs
5.
Side Locking Knobs
6.
U-Brackets
7.
H-Stand
8.
Locking Knob
9.
Tripod
10.
On/Off Switches
11.
Power Cord
FIG 1
8
15
14
A
B
1
7
15
D2
C2
D1
C1
B
F
FIG 2
3