Kohler K-6816 Manual Del Usuario página 8

Single-Post Accessories
Rod
Long Sleeve
Anchors
Screw
Wall Plate
Post
Center Cap
Short Sleeve
Washer
Bottom Cap
5. Install the Post
NOTE: If installing the towel ring, refer to the "For Multiple Post
Accessories and Towel Ring" instructions below.
NOTE: If installing the horizontal tissue holder, skip this step and
refer to the "Install the Horizontal Tissue Holder" section of this
guide.
NOTE: If installing the mirror, skip this step and refer to the "Install
the Mirror" section of this guide.
For Single-Post Accessories
Loosen the screws in the wall plate 1/4 turn to allow for
adjustment.
Remove the center cap packed with the post.
Temporarily place the post onto the wall plate so the hex slots in
the post are vertical.
Align the splines in the post with the splines on the wall plate.
NOTE: If the splines do not align, remove the post, then rotate the
wall plate slightly. Place the post over the wall plate to ensure the
splines are aligned. Repeat as necessary.
Gently remove the post and tighten the screws on the wall plate.
Place the long sleeve onto the rod, then slide the rod through the
hex slots of the post.
1020822-2-B
Multiple-Post Accessories
Wall Plate
Splines
Hex Slots
Escutcheon
Gasket
8
Sleeve
Hex Slot
Screw
Post
Kohler Co.