Emist EPIX360 Manual De Usuario página 12

EN
A. PREPARING THE SPRAY AREA:
1. Make sure food and drinks are removed, or covered before application.
2. Spotless, clean interiors require no prep work prior to application.
3. Loose debris must be swept from floors and other surfaces prior to
4. Inspect the area for mechanical barriers such as: magazines on table
5. Please cover and remove valuables. Electronics, furniture, paper or other
6. Once the area has been cleaned, application can begin.
7. This system is NOT a mechanical cleaner.
B. SPRAY APPLICATION PROCESS:
1. EMist recommends the use of disinfecting products on EPA's Disinfection
2. Begin at the farthest point from the doorway, work back toward the
3. Aim applicator 24"-36" (optimal distance) from the surface target area,
4. Make sure you are working in a methodical "S" pattern and let your
5. Allow treated area to sit for contact time as recommended by the
TIP: IF THE APPLICATOR BECOMES WET OR BEGINS TO DRIP,
YOU ARE MOVING TOO SLOWLY OVER THE SURFACE TARGET
AREA AND NEED TO SPEED UP THE APPLICATION PROCESS.
DO NOT OVER-SATURATE THE SURFACE. IF YOU SEE RUNS
OR PUDDLES YOU ARE APPLYING TOO MUCH CHEMICAL. THE
GOAL IS TO ACHIEVE EVEN COVERAGE OVER THE TARGET
SURFACE AREA.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 Multilingual Manuals - 031721
SPRAY APPLICATION
application.
tops, chairs touching each other, a table or a wall. The intended target
surface area for application will need to be accessible.
common necessities do not need to be removed from the area.
List N that are approved for electrostatic application.
doorway so you can step out when application is complete.
begin with a smooth figure "S" movement aiming below, at, and above
the surface target area while walking at an average pace (continuously
moving).
passes overlap when moving to the next surface target area.
chemical manufacturer's label before re-entry into the area.