Ryobi AR2016G Manual Del Operador

OPERATOR'S MANUAL
ONE-WAY SCREW INSTALLER/REMOVER
AR2016G
WARNING:
To reduce the risk of injury, do not attempt to use
this product until you have read thoroughly and
understand completely this operator's manual and
the operator's manual for any power tools used. Al-
ways wear eye protection with side shields marked
to comply with ANSI Z87.1. Ensure compatibility
and fit before using this accessory. Do not use this
accessory if a part is damaged or missing.
PACKING LIST
See Figure 1.
Hex Key, Driving Bit (for screws #4-8), Driving Bit (for
screws #10-12), Driving Bit (for screws #14 and up),
and Guide Sleeve
INSTALLING/REMOVING ONE-WAY
SCREWS
See Figure 2.
To install a one-way screw:
 Install the appropriate bit into a drill (not included).
NOTE: This product can be installed onto any drill
(not included) with a 1/4 in. or larger chuck.
 Place the tip of the driving bit onto the head of the
one-way screw.
 Rotate the bit clockwise to install the screw into the
drilling surface.
To remove a one-way screw:
 Insert the hex key into the hole in the guide sleeve
and loosen the set screw.
 Select the appropriate driving bit.
 Place the tip of the driving bit onto the head of the
one-way screw.
 Slide the guide sleeve over the driving bit and onto
the drilling surface.
NOTE: Ensure the guide sleeve is flush against the
surface.
 Place the hex key into the hole in the guide sleeve
and tighten the set screw to secure the sleeve in
place.
 Using a drill (not included), rotate the bit
counterclockwise slowly while keeping constant
pressure on drill to loosen and remove the screw.
ONE WORLD TECHNOLOGIES, INC.
P .O. Box 1288, Anderson, SC 29622
1-800-525-2579 • www.ryobitools.com
Fig. 1
B
A - Hex key (clé hexagonale, llave hexagonal)
B - Driving bits (embouts de vissage, puntas para atornillar)
C - Guide sleeve (douille de guidage, manga guía)
Fig. 2
B
C
A
A
C
A - Guide sleeve (douille de guidage, manga guía)
B - Driving bit (embout de vissage, punta para atornillar)
C - One-way screw (vis à sens unique, tornillo de dirección
única)
D - Hex key (clé hexagonale, llave hexagonal)
A
B
C
D
C