PAPILLON 96849 Instrucciones página 23

Cod. 96849-99176
a. Cutting height positions (fig.2c)
1) 25mm (lowest cutting height position)
2) 40mm
3) 55mm(highest cutting height position)
VI-OPERATING
Connect to power supply
Warning! Before connecting to the mains supply, always check the switch is in off position. Connect the
plug into the RCD protected power supply.
Starting
On/Off switch fig.3)
Caution! Do not start the mower if it is standing in long grass. Press the safety
button (A) of the switch assembly and then pull the switch lever (B) against the
bar. Keep the switch lever held whilst releasing the safety button. To stop the
mower release the switch lever and it automatically returns to its off position.
Mowing (fig.4)
We recommend to use your mower as outlined in this section in order to achieve optimum results and to
reduce the risk of cutting the mains cable.
•
Place the bulk of the mains cable on the close to the starting point.
•
Switch the mower on as described above.
•
Proceed as shown in fig.4
•
Move from position 1 to position 2
•
Turn right and proceed towards position 3
•
Turn left and move towards position 4
•
Repeat the above procedures as required.
Warning! Do not work towards the cable.
4
2
Blade maintenance(fig.5)
Regularly remove grass and dirt from the blade.
At the beginning of the gardening season, carefully examine the condition of the blade.
If the blade is very blunt, sharpen or replace the blade.
If the blade is damaged or worn, fit a new blade.
If the blade is slipping, put the screwdriver into the location hole, tighten the blade by wrench. see
fig.6 and fig.7
Warning! Observe the following precautions:
Disconnect the mower from the mains and wait until the blade has stopped rotating before
proceeding.
Be careful not to cut yourself. Use heavy-duty gloves or a cloth to grip the blade.
Only use the specified replacement blade.
4
3
3
1