Memory Deletion - LEDS C4 Gea RGB Easy+ Instrucciones De Montaje

4.3- How to synchronize the remote control of the Master controller 71-E069

MEMORY DELETION

1.-Turn off the power.
2.-Hold the controller push button (Fig.1) while switching on the mains. Keep on holding the push button until the
fittings start flashing in blue colour. This means the controller memory has been erased.
SYNCHRO
3.-Turn on the mains. Switch off the controller by means of holding the controller push button (Fig.1).
4.-Hold down the controller push button (Fig.1) and the top button of the remote control (Fig.2) at the same time
until the fittings start flashing in green. This mean the synchronization has been done successfully.
5.-In case the fittings don't flash in green repeat the steps 3 and 4. In case the synchronization fails again check the
remote control batteries and repeat the steps from 1 to 4.