Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 4
INSTALL DUCTWORK
(REMOTE BLOWER - if used)
A.
Install the ductwork and remote blower (if used) in
accordance with the ductwork routing plan devel-
oped in Step 1.
B.
Make sure that the installation complies with all
installation guidelines in Table 2. Check the opening
where ducting passes through the outside wall or
roof has been properly flashed and sealed to prevent
leakage.
C.
If using integral blower model VTN600CVA pro-
ceed to Step 5.
D.
If using remote blower model VTR600R or
VTR1000Q, refer to Installation Instructions with
that model.
STEP 5
INSTALL ELECTRICAL SERVICE
Check your local building codes for proper method of
installation. In the U.S., if there are no applicable local
codes, this unit should be installed in accordance with the
National Electric Code ANSI/NFPA No. 70, Current Issue.
(In Canada, installation must be in accordance with the
CAN 1-B149.1 and .2 - Installation Codes for Gas Burning
Appliances and/ or local codes).
This appliance is factory equipped with a power supply
cord having a three-prong grounding plug (with polarized
parallel blades). IT MUST BE PLUGGED INTO A MATING
GROUNDING TYPE RECEPTACLE, CONNECTED TO
A CORRECTLY POLARIZED 120 VOLT CIRCUIT.
The receptacle should be located under the countertop so
that the 30 inch long power cord from the vent will reach
it. See Figure 9. The cord should be routed beneath the
appliance and away from heat generated by the cooktop.
Access should not be obstructed by blower, cabinet work,
ductwork or electrical/gas utilities for the cooktop. All
power for the vent system (including the remote blower,
if used) is supplied via the cord to the intake unit. The
outlet must have its own dedicated branch circuit from
the main service panel.
Do not plug vent cord into receptacle until Step 8.
STEP 6
MOUNT VENT & COOKTOP
A.
Remove grease filters and any packing materials from
inside the intake.
B.
Set the vent intake into rear of countertop opening.
Carefully lower it into position so that the flanges on
the rear sides and edges fully support the unit hanging
from the countertop.
C
Loosely fasten lower support legs to vent. Hold the
unit against the rear of the countertop opening, and,
with it in vertical position, slide the brackets down to
meet the bottom of cabinet and fasten to cabinet with
hardware provided. Then tighten brackets on vent.
Refer to Figure 1. Fasten support legs to cabinet
floor.
D.
Place the cooktop in countertop opening with the
rear edge of cooktop overlapping the front edge of
the vent. Make sure rear edge of cooktop does
not bind against front of snorkel. Follow the
manufacturer's installation instructions for installing
the cooktop.
Page 11
Publicidad
