Operation; Set Up The Product; Operation Tips - STERWINS ESH2-45.41 Instrucciones De Montaje, Utilización Y Mantenimiento

FR

7.OPERATION

ES
CAUTION:
·Before starting the product, make certain the feeding chamber is empty.
PT
·Keep your face and body away from the feed intake opening.
·Do not allow hands, or any other part of the body or clothing inside the feeding chamber,
IT
discharge chute, or any moving part.
·If the cutting mechanism strikes any foreign objects or if the product should start making
EL
any unusual noise or vibration, immediately shut off the power source and allow the
product to stop.
PL
·Disconnect the power source and inspect for damage or faults.
·Before operation, adjust the adjusting knob to release any foreign objects which may
RU
interfere with the cutting roller and counter blade.
·Switch on the tool, then adjust the adjusting knob, you should hear the cutting roller
touching the counter blade.
UA
·The shredder should produce small metal filings. Tighten the fixing knob, make sure the
counter blade is tight.
RO

SET UP THE PRODUCT

On a flat, level surface. Do not place the product on graveled ground.
EN
Work at a safe distance (at least 2 meters) away from walls or other objects.
BEFORE STARTING, MAKE SURE THAT:
·The connection cables are not damaged. If there are cuts or tears, stop operation and
replace it immediately.
·There is no damage on the product, and all screws are tight.
·The product is assembled completely and correctly.
Check the mains connection:
·Make sure that the mains voltage matches the rated voltage on the nameplate and the
product is properly grounded.
·Use only extension cords with sufficient core cross-section.
The shredder can process the following types of material:
·All types of branches up to the product's maximum diameter capacity of 45 mm,
depending on type and condition of the wood.
·Dry garden refuse such as plants, which should be dried before shredding and fed
alternately with branches to avoid blocking the shredder.
The shredder can NOT process the following types of material:
·Glass, metal, plastic, stone, ceramics, thicker branches, hard wood, thick wood plates,
cloth, plastic bags, roots with soil.
·Refuse which is in an almost liquid state, e.g. kitchen waste.

OPERATION TIPS

·Feed the material into the filling hopper from the right side.
258