Publicidad
4. Make sure your air purifier is plugged in and powered up.
YOU WILL NOW NEED TO RESET THE FILTER INDICATOR.
5. Reset the filter indicator light by pressing and holding down the night light
button for 3 seconds. This will reset the filter indicator light.
FEATURES AND SPECIFICATIONS
Our H13 High-Grade HEPA filter captures up to 99.9% of airborne particles
0.1 Micron or larger including bacteria and various contaminants as well as dust,
pollen and odors from cooking, smoke, pets and VOC's. The CAP-500 quiet DC
motor has a dual filter system that purifies air in an up to 500-sq. ft. area two
times every hour or in an up to 250-sq. ft. area four times every hour.
3-STAGE DUAL AIR INTAKE H13 HIGH GRADE
HEPA FILTRATION SYSTEM
• HEPA H13 – H13 high-grade HEPA filters capture up to 99.9% of airborne
particles 0.1 Micron or larger including bacteria and various contaminants
• ACTIVE CARBON FILTERS – Captures up to 99.9% of various unwanted
cooking odors, smoke and VOCs to 0.1 Micron or larger
• REMOVABLE, REUSABLE METAL PRE-FILTERS – Captures larger
airborne particles such as dust, pet dander and cooking oils
CLEANING AND MAINTENANCE
The H13 high-grade HEPA filters could be vacuumed once a month in order for
the air purifier to perform at its best. If the air purifier contains dust or pet dander,
it's best to clean the removable metal pre-filters more often than once a month to
maintain 2,500 hours of filter life. Always unplug your air purifier from the electrical
outlet before replacing or removing any filters.
1. Unplug the power cord from the unit and from the outlet. The metal pre-filters
are to be hand-washed only. If the filters are fairly clean, wash each filter with
soapy, warm water. If the pre-filters are very dirty, you may need use a soft
brush to gently clean them. Make sure the pre-filters are completely dry before
placing back into the unit.
2. Remove the HEPA H13 and active carbon filters as described on page 4.
3. The best way to clean the HEPA H13 filters is to use a vacuum cleaner with the
brush attachment. Gently run the brush attachment along the white side of the
filter only. You do not need to vacuum the active carbon filter on the other side
of the HEPA H13 filter.
5
Publicidad
