Tripp-Lite RBC48V-HGTWR Hoja De Instrucciones

Battery Replacement
Under normal conditions, the original battery in your UPS will last several years. Battery replacement
should be performed only by qualified service personnel. Refer to "Battery Warnings" in the Safety
section. Should your UPS require battery replacement, visit Tripp Lite on the Web at
www.tripplite.com/support/battery/index.cfm to locate the specific replacement battery for your UPS.
Carefully pull the front
1
panel away from the
UPS.
Place front panel on top of the unit.
Remove battery cover.
2
Disconnect the wiring harness connecting
the batteries to the unit. Use a screwdriver
to remove the screws holding the battery
cover to the unit and carefully remove the
cover.
Remove old battery
3
pack.
Carefully pull the batteries from the UPS
by using the pull tab.
Connect new batteries.
4
Carefully push the new battery pack
back into the UPS.
Reassemble UPS.
5
Reinstall the battery cover, connect the
battery wires to the UPS and install the
front panel.
Tripp Lite has a policy of continuous improvement. Product specifications are subject to change without notice.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage V
201206033-933228.indd 1
Instruction Sheet
RBC48V-HGTWR
Replacement
Battery Pack
: DC Voltage
1111 W. 35th Street, Chicago, IL 60609 USA
www.tripplite.com/support
Copyright © 2012 Tripp Lite. All rights reserved.
SmartPro is a registered trademark of Tripp Lite.
®
1
2
3
4-5
1
201206033-933228-EN
6/21/2012 10:54:14 AM