How To Program Features; Programmable Features - Omega Freedom 550CF Manual De Instrucciones

To access Features Programming Mode:
Step 1: Turn the vehicle's ignition "On" then "Off".
Step 2: Within 7 seconds of turning the ignition "Off", press the Valet Switch 5
times. The siren will wolf once confirming entry to Features Programming Mode.
Step 3: Within 10 seconds of entering Features Programming Mode, press the
Valet Switch the number of times equal to the number of the feature to be
programmed. The siren will repeat the feature number with chirps to confirm.
Step 4: After the system acknowledges the feature to be programmed:
- press the "Lock" button on the remote to turn the feature "ON" (the siren will
chirp once), or,
- press the "Unlock" Button to turn feature "OFF" (siren will chirp twice).
Note: Once the feature to be programed is selected, you can toggle the
feature between its settings by pressing the "Lock" & "Unlock" buttons on
the remote control.
- To program more features, simply repeat Steps 3 and 4.
- If 10 seconds expire without any programming activity, or if the vehicle's igni-
tion is turned "On", the alarm will automatically exit Features Programming
Mode. The siren will confirm exit.
The alarm has 14 programmable features which allow it to be customized to suite
many individual needs. The following pages provide a brief explanation for each
feature, and notes its factory default setting.
• = Default Factory Setting
1. Pin Code: ( 1-12 , • Default 1 press)
- Allows user to program a "Pin-code" between 1-12 presses of the Valet/
Override button for use in Emergency override situations.
a. Enter Features programming mode and select feature
b. Within 10 seconds, slowly press and release the remote control's "Lock"
button a number of times equal to the desired "Pin-code", (The siren will
chirp every time the remote's Lock button is pressed to confirm that its
entry was registered, wait for the chirp before pressing button again).
c. 4 seconds after the last press of the remote control's "Lock" button, the
siren will chirp the new "Pin-code" to confirm the number that has been
entered.
d. User can program another feature by pressing the Valet button to select
next feature to be programed (step 3).

How to Program Features

Programmable Features

Page 10
#
1.