Aiwa TS-990 CD Manual De Usuario página 8

14
en
BLUETOOTH MODE
BLUETOOTH PAIRING
To use the Bluetooth function, your speaker should first be paired with your Bluetooth device.
("Pairing" means establish connection between Bluetooth devices such as mobile phone, tablets,
pc, etc).
1. Press the SOURCE button to switch to
Bluetooth mode
"BT" .
(fig. 1)
In Bluetooth mode, a voice prompt will
2.
announce Bluetooth pairing mode and the
word "BT" will flash on the display.
The speaker will search automatically for
Bluetooth devices.
Turn on the Bluetooth function on your
3.
device and make it visible (see your
devices instructions to add or setup a
Bluetooth device).
4. Search for Bluetooth devices and select
AIWA TS-990CD
Enter the code "0000" if needed.
(fig. 2)
If the devices are paired successfully, the
word "BT" on the display will keep bright.
Having successfully paired, the device will
be automatically connected next time.
5. Press and hold for 2 seconds to
disconnect the Bluetooth.
(fig. 3)
PLAY FROM A BLUETOOTH DEVICE
Press the button to play.
1.
2. To pause or resume play, press the
button again.
Press the or buttons to skip to a
3.
different track number.
Notes:
• Compatibility with all Bluetooth devices
is not guaranteed.
• Bluetooth playback can be controlled
from the external device, the top panel of
the tower, or the remote control.
USB/SD CARD MODE
PLAYING MUSIC VIA USB OR SD CARD
This speaker has been developed using the
latest technical advances in the USB or SD
field. However, given the wide range of USB/
SD storage device types that are currently in
the market, we unfortunately cannot guarantee
full compatibility with all of them. For this
reason, in rare cases, there may be problems
in playing files from USB/SD storage devices.
This is not due to the devices malfunction.
Press the button to turn on the unit.
1.
2. Press the SOURCE button repeteadly until
the "USB" or "CARD" function appears on
the display.
Connect a USB/SD storage device directly
3.
to the USB or SD CARD ports. The display
briefly shows the number of folders and
then the total number of tracks. Playback
will automatically start after a few seconds.
4. To temporarily stop playback, press the
button, and to resume playback, press
it again.
5. Press the or
different track number
Press the or
6.
scroll between the playable music folders
of the device.
7. Press the button to stop play.
SEARCHING FOR A SECTION WITHIN AN
AUDIO FILE
(fig. 2)
During playback, press and hold the
or buttons to find a specific passage
within the track and release it at the
point you want to listen to.
Notes:
• Because some storage devices have a
large capacity, USB or SD access times
are a little longer.
• Switch the device to a different operating
mode before you remove the USB or SD
storage device.
• To avoid malfunctions never connect a
USB storage medium to the USB charging
port.
(fig. 3)
LINE-IN MODE
AUXILIARY INPUT FUNCTION MODE
This unit can be used as an active speaker for
laptop computers, MP3 and other small audio
players following the steps below.
1. Press the
2. Press the SOURCE button repeatedly until
the "LINE" function appears on the display.
Connect an auxiliary cable ended in 3.5mm
3.
jack to the AUX IN socket.
4. Start playback on the external audio device.
Adjust the volume on the audio device (do
not set the volume to a high level in order
to avoid distortion). You may also adjust
the volume on the apparatus. To control
playback function, use the controls on the
external audio device.
Note:
• The auxiliary input mode only allows the
user to control the volume from the unit.
buttons to jump to a
.
buttons on the remote to
button to turn on the unit.
15