Installation - SCHOLTES BQ 50TC Manual De Instrucciones

Installation

! Before operating your new appliance please read this
instruction booklet carefully. It contains important
information for safe use, installation and care of the
appliance.
! Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.
Positioning
! Keep packaging material out of the reach of children. It
can become a choking or suffocation hazard (see
Precautions and tips).
! The appliance must be installed by a qualified
professional according to the instructions provided.
Incorrect installation may cause harm to people and
animals or may damage property.
! This unit may be installed and used only in permanently
ventilated rooms in accordance with British Standard
Codes Of Practice: B.S. 6172 / B.S. 5440, Par. 2 and B.S.
6891 Current Editions. The following requirements must be
observed:
• The room must be equipped with an air extraction
system that expels any combustion fumes. This may
consist of a hood or an electric fan that automatically
starts each time the appliance is switched on.
In a chimney stack or branched flue.
(exclusively for cooking appliances)
• The room must also allow proper air circulation, as air is
needed for combustion to occur normally. The flow of air
must not be less than 2 m3/h per
kW of installed power.
The air circulation system may
take air directly from the outside
by means of a pipe with an inner
A
cross section of at least 100
Examples of ventilation holes
for comburant air.
cm2; the opening must not be
vulnerable to any type of
blockages.
Adjacent Room to be
Room Vented
The system can also provide the
air needed for combustion
indirectly, i.e. from adjacent rooms
fitted with air circulation tubes as
described above. However, these
Enlarging the ventilation slot
between window and floor.
rooms must not be communal
• Liquid petroleum gas sinks to the floor as it is heavier
Fitting the appliance
Gas and mixed hobs are manufactured with type X degree
protection against overheating. The following precautions
must be taken when installing the hob:
• Kitchen cabinets adjacent to the appliance and taller
• Hoods must be installed according to their relative
Directly to
the Outside
Installation Installation Installation
Installation Installation
Make sure you take all the necessary precautions to guarantee
proper installation in compliance with the applicable norms in
force regarding accident-prevention for electrical connection. For
the correct operation of the appliance when built into the cabinet,
it is vital that the minimum distances illustrated in Fig. 1 be
respected. The hob features a type Y degree of protection against
overheating in compliance with norms. All surfaces adjacent to
the cabinet and the back panel should be made of materials
resistant to a temperature of 65°C.
rooms, bedrooms or rooms that may present a fire
hazard.
than air. Therefore, rooms containing LPG cylinders
must also be equipped with vents to allow gas to
escape in the event of a leak. As a result LPG
cylinders, whether partially or completely full, must not
be installed or stored in rooms or storage areas that are
below ground level (cellars, etc.). It is advisable to keep
only the cylinder being used in the room, positioned so
that it is not subject to heat produced by external
sources (ovens, fireplaces, stoves, etc. ) which could
raise the temperature of the cylinder above 50°C.
than the top of the hob must be at least 50 mm from the
edge of the hob.
installation instruction manuals and at a minimum
distance of 700 mm from the hob.
• Place the wall cabinets
adjacent to the hood at a
minimum height of 540 mm from
the hob (see figure).
600mm min.
If the hob is installed beneath a
wall cabinet, the latter must be
situated at a minimum of 700 mm
above the hob (see figure).
GB
15