Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Contents
Auto Reel
A
Wall Bracket
B
Feeder Hose
C
Threaded Tap Connector
D
Hose End Connector
E
Waterstop Connector
F
Wall Plugs and Screws
G
Hose Nozzle
H
Quick hints and tips
• When mounting the reel, ensure that nothing
obstructs the reel from swinging freely through 180°.
• It is critical to use a 7mm drill when drilling holes to
mount the reel.
• Ensure the wall bracket is mounted vertically using a
spirit level.
• Check that the reel is locked onto the bracket before
turning on water supply.
• The hose will not rewind unless it is pulled a short
distance (15 to 30cm) away from the reel and then
walked back towards the reel.
• If the hose will not rewind, try the following;
Turn off the tap and let the water out of the hose by
opening the hose nozzle/gun.
Walk back to the reel with the end of the hose and
trigger the rewind mechanism by taking hold of the
hose near to the reel, and gently pull the hose about
15 to 30cm to release the latch.
(Ensure that nothing is obstructing the hose whilst
the rewind procedure is active.)
• Use the lock on the side of the reel to lock the hose
when not in use.
Installation of the Auto Reel
TOOLS NEEDED:
• Flat-ended, long shaft screwdriver
• Philips screwdriver
• Pencil
• Tape measure
• 7mm diameter masonry drill bit
• Electric drill/hammer drill
• Spirit level
FIT THE WATER INLET HOSE
FIG.1
• Remove the water connector as shown.
FIG.2
• Insert the 2m feeder hose through the reel.
FIG.3
• Fit the water connector to the end of the feeder hose
using the hose nut.
• Take the 2 small screws and partially screw them
into the retaining clip as shown
• Fit the retaining clip to the water connector.
FIG.4
• Place the safety disc over the water inlet. Insert the
water connector back into the reel and align the 2
screw holes.
FIG.5
• Screw the 2 screws into the reel
FIG.6
• Fit the trim cap to the reel.
FIG.7
• Attach the 'water stop' hose end connector to the
end of the main hose.
SELECT A SUITABLE POSITION FOR
INSTALLATION
FIG.8
• The reel should be allowed to swivel through 180
degrees. Allow 40cm clearance on both sides of the
wall bracket.
• If the hose is to be used around a corner, mount
the reel at least 1m from the corner and use a hose
guide, part No. 2392, which is not supplied.
FIXING THE WALL BRACKET
FIG.9
• The 4 plugs and screws supplied are for use on
standard brick, concrete or timber walls only. To fix
the bracket to any other surface, you should use
screws and plugs appropriate for that surface.
• A template is supplied, on the box, to help align the
screw hole positions.
INSTALLING THE REEL
FIG.10
• Align the back of the reel with the wall bracket and
insert the grey pivot tube.
• Attach the remaining hose end connector to the free
end of the feeder hose.
Publicidad
