Game ready GRPRO 2.1 Guia Del Usuario

FOR USE WITH
GAME READY
GRPRO 2.1 SYSTEM
®
ASSEMBLY
The Vest Heat Exchanger fits inside the Vest Sleeve and comes
pre-assembled. If the Heat Exchanger is removed to launder the
Sleeve or for any other reason, please use the following instructions to
re-insert the Heat Exchanger into the Sleeve.
1
Place the Vest Sleeve completely open,
flat, with blue side down. Front panels
should be pointing away from you as
picture shows.
2
Place the Heat Exchanger in the same
orientation, with the blue side down.
REMOVAL OF HEAT EXCHANGER
1. Disconnect the Connector Hose from the Cooling Vest
2. Unzip the back zipper
3. Gently pull out the Heat Exchanger
COOLING
WARNING
It is mandatory to fully read and understand the
Game Ready GRPro 2.1 User Manual before using
the device. Failure to follow operating instructions
could result in serious injury.
IMPORTANT
Read complete indications, contraindications,
cautions, and warning before using this product.
Keep this document for future reference.
3
Open the horizontal, back zipper on the
Vest Sleeve. Insert the Heat Exchanger
into the sleeve, matching the orientation
(blue to blue). Make sure the Heat
Exchanger is inside the Sleeve with no
folds or creases that might block flow of
water through the channels of the Heat
Exchanger. Close the back zipper. The
Cooling Vest is ready to use.
STORAGE OF YOUR COOLING VEST
Hang your Cooling Vest on a wide hanger or lay flat. Do not fold or
stack it, as this could kink the fluid chamber and the Vest will not work
properly.
VEST
USE GUIDE
ENGLISH