Publicidad
1
BOTTOM SLOT INSTALLATION ON CROSSBARS.
Determine which carriage bolt you will need based on the thickness
of your crossbars. For thinner crossbars use the shorter bolt. For
thicker crossbars use the longer bolts. NOTE: If you intend to use
the included accessory locks (recommended) use the longer bolts.
NOTE: Generally, RoadShower™
is installed using the bottom slot.
The side slot on the RoadShower
is only for custom installations.
See page 7 for more information
about custom installations.
2
POSITION THE ROADSHOWER
Set the RoadShower™ onto
your crossbars inboard of
the towers with the bolts
straddling your crossbars.
3
INSTALL THE CLAMPS.
Assemble the clamps around the crossbar as shown and use a 1⁄2" wrench to install the washers
and nuts . Tighten completely to 2 Nm. Push and pull at the RoadShower to verify installation.
NOTE: Use of the included accessory locks are recommended See page 7 for instructions.
Instruction #1036081B - page 4 of 12
INSTALLATION
.
™
2 Nm
Insert 4 carriage bolts into
the slot on the bottom of the
RoadShower™. Slide 2 bolts to
the left and 2 bolts to right.
NOTE: The maximum
overhang fore or aft
of the front and rear
crossbar is not to
exceed 30" (76 cm).
30"
30"
(76 cm)
(76 cm)
Publicidad
