HUROM H-200 Serie Manual Del Usuario página 5

5. How to Assemble
08
01 02
⑤-1
/⑥-1
⑦-5
05
04
②-3
⑦-1
01
Make sure to align groove in the chamber(⑦-5) external strainer wing(⑤/⑥).
02
Assemble the inner strainer and squeezing screw onto the external strainer of chamber.
The settlement point of the inner strainer (④-1) and the wing of outer strainer (⑤-1 / ⑥-1) should
be aligned in place.
03
Place the hopper lid (①-3) vertically onto the hopper (②-1).
04
Align the guide mark (⑦-1) of the hopper [ ] with the guide mark (②-3) of the chamber [
05 Turn the assembled hopper clockwise until its guide mark is aligned with the guide mark [
] on the chamber.
If the internal components are not assembled correctly, the hopper will not close properly.
06
Make sure the discharge cover (⑦-2) of the chamber is properly fastened with the loop.
1. Close the discharge cover and fasten it with the loop.
2. If the silicone parts are not plugged in place, or the lever is not fastened,
juice may leak or the lever may open during extraction.
07
Place the well-assembled chamber set onto the base.
03
③
①-3
④-1
②-1
⑦-5
06
①
⑦-2
6. Plugging and Unplugging Silicone
※ Silicone packings are supposed to be replaced
every 6 to 12 months. You can purchase them
through our Customer Service Center.
(The juicer may leak if the product is not assembled
properly.)
Extraction Packing
01
02
Seal Packing
01
02
].
01 Hold the silicone ring and pull it out smoothly.
02 After cleaning, plug the silicone ring upright into
the slot by fixing one end into place first.
03 Insert the rest and press down firmly.
Juice Cap Packing
⑦-3
After cleaning, firmly insert with the round side
outward and the grid hollow facing upward.
Hopper Packing
⑦-3
②-4
Plug the silicone packings upright.
Chamber Packing
⑦-4
⑦-4
01 Grab onto one side and pull out.
02 After cleaning, plug the silicone rings upright
into the slot as if it is hanged one side first.
03 Press the rest of packing down along the slot
in place without any folded part.
09
⑦-8
⑦-6