Tabla de contenido
Publicidad
ENGLISH
•
Do not leave the appliance unattended while plugged in.
•
Do not place the appliance on any soft furnishings.
•
Do not use attachments other than those we supply.
•
Do not set the appliance down while still on.
•
Do not twist or kink the cable, or wrap it round the appliance.
•
Do not use the appliance if it is damaged or malfunctions.
•
Check the cord regularly for any sign damage.
•
Always ensure that the rear grille/filter is clear of any hair, fluff or other debris before
use. A blocked grille/filter can cause the appliance to overheat.
•
This appliance is not intended for commercial or salon use.
PARTS
1. Grille
2. Heat selector switch (N, O, P)
3. Speed selector switch (0, F , E)
4. Cool shot
5. Turbo function
6. Ion indicator light
INSTRUCTIONS FOR USE
•
Wash and condition your hair as normal.
•
Squeeze out excess moisture with a towel and comb through.
•
Hairsprays contain flammable material – do not use while using this product.
•
Fit accessory attachments to the front of the hairdryer then twist clockwise to lock in
place. Take care when you do this because the attachments can become hot during
use.
1.
Plug the product into the mains power supply.
2.
Switch your hairdryer on and select the desired speed setting using the speed selector
switch.
3.
Select the desired heat setting (low N, medium O or high P) using the heat selector
switch.
4.
For the fastest air flow use the turbo function. To operate, press the turbo function
button ( ) and hold it there. Release the button to return to normal drying.
5.
After use, turn the appliance off and unplug it.
How to create curls with the curling attachment
1.
For best results, dry your hair as normal until it is about 70% dry. Then turn off your
dryer and section your hair into manageable areas.
2.
Fit the curling attachment to the front of the hairdryer then twist clockwise to lock in
place. Take care when you do this because the attachments can become hot in use.
4
7. Smoothing attachment
8. Curling attachment
9. Diffuser attachment
10. Inlet grille
11. Hang up loop
12. 45 mm round brush (not shown)
Publicidad
Tabla de contenido
