optrel e3000X Manual De Instrucciones página 12

Ocultar thumbs Ver también para e3000X:
Tabla de contenido

Publicidad

Adjusting the air flow: The blower has three air flow levels: 170/210/240 L/
min. To change the air flow level, press the air flow button and scroll through
the different levels until the desired level is reached (Fig. 11).
Replacing the main filter and prefilter: If a filter alarm is output, the prefilter
must be replaced (Fig. 12). Please monitor the time between filter alarms.
This becomes shorter each time the prefilter is replaced. If you have
the impression that the change intervals are too short (this is a personal
impression), it is recommended to replace the main filter and the prefilter
(Fig� 13)�
Alarm function
Filter clogging alarm: When the filter clogging alarm is tripped, the LED
shows red. Without action, the flow levels III and II change to one lower. To
replace the prefilter and main filter, press and hold the On/Off button for 2
seconds to turn off the e3000X. You can now change the filters.
Battery alarm: When the battery alarm is triggered, the LED shows red. A
beep is emitted every second; you can continue using the device for approx�
30 minutes�
Storage
The e3000X system and accessories must be stored in a dry place� Protect
it against sunlight, high temperatures, hydrocarbons and solvent vapours.
Maintenance
Check the helmet regularly according to the operating instructions� Check
the face seal and the air nozzle for holes, cracks or other damage and make
sure that the parts are correctly positioned on the helmet (see instruction
manual)� Do not use the system until all worn or damaged parts have been
replaced�
Maintenance schedule
Activity
Cleaning, disinfection
Visual inspection
Charging the battery
Replace seal between main filter and
blower unit
For use in industry and craft Optrel recommends that the unit be serviced
at least once a year by an Optrel qualified service company. This is a
recommendation and not a requirement. When the device is in storage, the
battery must be recharged every 4 months�
Cleaning and disinfection
Clean the blower, air hose and helmet using a cloth moistened with soapy
water� Allow the unit to dry at room temperature� Do not use aggressive
cleaning agents or solvents, alcohol or abrasive cleaning agents. The
mechanical seal is washable (hand wash, do not spin).
Troubleshooting
Blower does not switch on
→ Make sure the battery is inserted correctly.
→ Make sure the battery is fully charged.
Filter alarm is activated even though the pre- and main filters have been
replaced and are correctly installed
→ Internal e3000X error
→ Return the e3000X system to the nearest dealer.
Battery life is too short
→ Battery defective – Replace battery and dispose of defective battery as
hazardous waste�
→ Charger defective - replace.
Technical data
(We reserve the right to make technical changes.)
Nominal protection factor Europe: TH3P/TH2P classification (see page IV)
Australia: P3 classification
Blower unit
Air flow rates:
Material
PC + ABS
Frequency
Always after use
Always before and after use
After each use
Replace if the seal is worn or damaged,
but at least 1x per year
Level 1: min. 170 L/min
Level 2: min. 210 L/min
Level 3: min. 240 L/min
Blower
High-quality, ball-bearing mounted blower motor
Fuse
Electronic fuse
Battery
Type:
Voltage / capacity:
Charging cycles:
Operating time level 1*
Operating time level 2*
Operating time level 3*
Charging time:
Weight:
Colour:
*min. operating time with new filter at room temperature
Noise level
Max� 70 dB(A)
Warning signals
Audible and visual alarm for low battery, clogged or
missing filter and low airflow
Filter
1x type TH3P R SL
for TH3P system (Europe)/TH3P system (Australia)
Air hose
Length:
Diameter:
Weight:
cover)
Colour:
Weight
1195g / 42.152 oz (incl. filter and belt, without battery)
Dimensions
LxWxH: 222 x 213 x 92.6 mm
Standards
EN 12941:1998 /A2:2008, EAC TP TC 019/2011,
AS/NZS 1716
Notified body
CE 1024
Scope of delivery/Spare parts (see page I, II, lll)
1 e3000X PAPR
2 Main filters TH3P R SL filter for TH3P system (Europe)/TH3P system
(Australia)
3 Prefilter
4 Spark protection
5 Filter cover
6 Standard battery (Lithium-Ion 48 Wh)
7 PAPR-compatible safety helmet
9 Hose
10 Protective cover for air hose (accessories, not included)
Further accessories can be found in the main catalogue or on our website�
Explanation of symbols (see page VI)
A Read operating instructions before use
B Do not open with sharp objects
C Fragile content
D Store with this side facing up
E Protect from moisture
F Notified body identification mark
G Mark of conformity EAC (Russia)
H Contains lithium ions
I Plastic, recyclable
J Recommended storage temperature: 5 C° to +25 C°
K Do not dispose of as domestic waste� Dispose of as hazardous
waste�
Declaration of Conformity
See the Internet address on the last page�
Legal information
This document complies with the requirements of EU Regulation
2016/425 section 1�4 of Annex II�
Notified body
For detailed information see last page�
12
Li-Ion rechargeable
14�8V / 3�25Ah
> 500
18 h
16 h
13 h
approx� 5h
420g / 14�815 oz
black
1160 mm (elastic upto 1300mm with
protective sleeve)
31 mm (inside)
185g / 6.526 oz (without protective
black

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

E600E684

Tabla de contenido