General Information; Unpacking And Installation - RCBS BRASS BOSS 90390 Instrucciones Del Producto

This product is intended for use by persons familiar with proper handloading practices and their own loading
equipment. If you are uncertain as to the operation of any of your equipment, contact the equipment
manufacturer for additional assistance.
Because RCBS has no control over the choice of components, the manner in which they are assembled, the
use of this product, or the manufacturing or condition of guns in which the resulting ammunition may be
used, no responsibility—either expressed or implied—is assumed for the use of ammunition reloaded with
this product.

GENERAL INFORMATION

Congratulations on your purchase of the RCBS Brass Boss™ Case Prep Center. It is the perfect addition to
any reloading bench and the ideal partner for the Trim Pro™ series of power case trimmers. With six rotating
gear-driven stations, Brass Boss speeds up several important but time consuming case preparation tasks
such as case chamfering and deburring, primer pocket cleaning and uniforming, military crimp removal and
fl ash hole deburring. There are also two stationary positions for case neck brushes or other accessories and a
cupped area for securing dry case neck lube. A handy on-off variable speed control switch is located on back
of the unit and a 4' DC power supply power cord allows you to position Brass Boss in a convenient spot on your
reloading bench. Please read these instructions completely before using the Brass Boss.

UNPACKING AND INSTALLATION

Shown below is a Brass Boss and all the accessories that are shipped with the unit. Carefully unpack the Brass
Boss and look for and identify the items listed below.
D
A
C E F G H
• Brass Boss case preparation center (A)
• 120V-240V DC power supply and AC power cord (B)
• Inside VLD Chamfering Tool (C)
• Outside Deburring Tool (D)
B
• Primer Pocket Cleaner, small and large (E)
• Military Crimp Remover, small and large (F)
• Primer Pocket Uniformer, small and large rifl e (G)
• Case Neck Brushes – four diameters (H)
• Dry Case Neck Lubricant (not shown)
5