Nacon GC-100XF Manual Del Usuario página 3

7
5
1
9
3
10
I First-time connection with the PC
The NACON GC-100XF is a so-called Plug´n´Play device. This means that the necessary driver
software should be installed automatically if you connect it to your computer for the fi rst time.
Here are the steps in detail:
• Turn on your computer, wait for it to boot and log in to your Windows desktop.
• Look for an unused USB slot on your PC and plug in the USB cable of your NACON GC-100XF
controller.
• Windows will detect the new device and after a few seconds it will start the installation process
for the appropriate drivers. This is shown by a small icon in the taskbar.
• The installation might take a while depending on the speed of your system. Once the installation
is complete, you will be presented with the according message. You can now use your GC-100XF.
I D/X button
There are diff erent ways for modern computer games to communicate with your controller
and vice versa. Your GC-100XF supports the two most commonly used ones: DirectInput8
and XInput.
Sometimes a game only supports one of these two protocols. Since both can´t be run
simultaneously, your GC-100XF features the D/X button (10) to switch between these two
protocols, to make sure it works with all games.
The blue LED's around the MODE button (9) indicate the current status:
• All LED's lit (full circle) indicates XInput to be used
• Partially lit LED's indicate that the DirectInput8 protocol is active
Remark: After changing the protocol, the controller needs some short time to switch, indicated by the lights
turning off. Once lit again, it´s fully functional with the selected protocol.
EN /
8
6
4
2