Operating Instructions - Black and Decker BH1607 Manual De Instrucciones

SET UP & USE

OPERATING INSTRUCTIONS

Place the heater on a firm, level surface and plug the unit directly into a 120V AC
electrical outlet.
Turning the Heater ON/OFF: Turn ON the power switch, located on the back of the
unit, and then press
again to OFF (00), so the heater goes to standby mode. To Shut the unit completely
Power off the switch located on back of the unit.
Selecting the heat level: Once the unit is On, press the Mode button.
a. Press once to select Fan mode and a LED light next to the Fan feature is illuminated
on the control panel to show the unit is in fan mode.
b. Press twice to select Low heat setting (750 Watts), and a LED light next to the Low
feature is illuminated on the control panel to show the unit is operating at Low Heat.
c. Press thrice to select High heat setting (1500 Watts), and a LED light next to the
High feature is illuminated on the control panel to show the unit is operating at High
Heat.
Selecting the Heat Level Manually:
You can select the heat level manually by setting the Thermostat temperature from 59
degrees to 99 degrees (set temperature will display on LED panel), by pressing the UP and
Down buttons located on the control Panel.
Note: if the set temperature is lower the prevailing room temperature the heater will
stop automatically and will begin to blow cool air. To constantly run the heater without
thermostat setting just select high or low heat by pressing mode button.
Setting the Timer:
You can set the timer on the heater to select the number of hours you want the unit to
operate. Press the Timer button once and a LED light blinks next to the timer feature on the
control panel, then press the UP and Down buttons to adjust the shut Off timer between 1
to12 Hrs.
MODE UP
button. Press once to On position the heater will start, press
POWER HIGH
LOCK
LOW
TIMER FAN
DOWN TIMER
Control panel
Page 7