Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
the number on the collar, the higher the torque and the
larger the fastener which can be driven. To select any of
the numbers, rotate until the desired number aligns with
the arrow.
nOTE: The torque adjustment collar is only engaged during
screwdriving mode and not in drill mode.
Speed Selector (Fig. C, D)
The speed selector feature of your drill allows you to shift
gears for greater versatility.
•
To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide speed selector
away from the chuck.
•
To select the high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide speed selector
back toward the chuck.
nOTE: Do not change gears when tool is running. If you are
having trouble changing gears, make sure that the speed
selector is either completely pushed forward or completely
pushed back.
Fig. C
Fig. D
Keyless Chuck (Fig. E–G)
WARNING: Make certain the battery pack is removed
to prevent tool actuation before installing or
removing accessories.
To insert a drill bit or other accessory:
8
1. Grasp the keyless chuck
counterclockwise direction, as viewed from the
chuck end.
2. Insert the bit or other accessory fully into the chuck, and
tighten securely by rotating the chuck in the clockwise
direction as viewed from the chuck end.
WARNING: Do not attempt to tighten or loosen drill
bits (or any other accessory) by gripping the front
part of the chuck and turning the tool on. Damage
to the chuck and personal injury may occur when
changing accessories.
4
Fig. E
4
Fig. F
4
Fig. G
4
6
and rotate it in the
6
Publicidad
Tabla de contenido
